In the entire industrial door system, the electronic control system accounts for a large part of the entire door, which is very important, and the motor is generally installed above the side of the industrial door, which is not conspicuous, and is usually not noticed, and in the daily use of the industrial door, only the correct operation of the motor can effectively ensure the normal use and service life of the motor. Of course, it is not enough to use it correctly, but under the premise of correct use, the industrial door motor should be well maintained, so that the motor of the industrial door can be used longer, and it can also save costs for enterprises.
The motor of the industrial door because of the long-term operation, there will definitely be a certain shaft loss, so it is necessary to regularly add oil to the industrial door motor, if not added, the motor is prone to various failures, such as motor jitter, noise and even motor burnout, etc., so it is necessary to regularly add oil to the motor to prevent these situations.
At the same time, the installation environment of the industrial door is also very important, try not to install in a humid, dusty environment, because the electronic components in the motor are easy to damp, leakage, short circuit, failure and other situations may occur, affecting the normal use of the industrial door, and even threatening personal and property safety. However, the motor of the industrial door can not be exposed to sunlight for a long time, because if it is exposed to sunlight for a long time, the exterior of the motor and the internal electronic components will be easy to age, which will seriously affect the service life of the motor.
During the use of industrial doors, we should always pay attention to whether each electronic control component is intact, if you find that a certain electronic accessory is damaged, you must communicate with the manufacturer in advance, so that professional industrial door manufacturers can judge whether they need to replace the accessories, if they need to be replaced, whether the manufacturer needs to go to the site, so as to ensure the safe and smooth use of the industrial door.
