1. For the motor equipped with rolling bearings, the bearing cover should be removed first, and then loosen the fastening screws of the end cover, and mark the joint between the end cover and the base shell, and screw the removed screw to fasten the end cover into the two screw holes specially set on the motor end cover to eject the end cover.
2. Remove the external wiring of the trackless segmented door motor first, and mark it. Then loosen the foot screw to separate the motor from the transmission machinery.
3. When disassembling the trackless segmented door motor with brushes, the brushes should be taken out from the brush grip, and the position of the brush neutral wire should be marked.
4. When pulling out the rotor, you must pay attention not to hurt the stator coil, the weight of the rotor is not large, you can withdraw it by hand; If the weight is large, it should be hoisted with lifting equipment.
5. To disassemble the pulley or coupling on the shaft of the trackless segmented door motor, sometimes it is necessary to add some kerosene in the gap between the motor shaft of the pulley to make it penetrate and lubricate, which is easy to disassemble.
Trivia: Trackless segmented door motor It is a motor that can realize the mutual conversion of DC electrical energy and mechanical energy, and is the hub for energy conversion, so it is usually called an armature, which is composed of a rotating shaft, an armature core, an armature winding, a commutator and a fan.
